How to Patch a Carpet

It’s inevitable that one day you will need to patch up your carpet. It’s important, as a homeowner, to know how to take care of little issues like this. Knowing how to complete tasks like this could save you a lot of money and time in the long run. Things cigarette burns, spills, and other messes could ruin parts of your carpet. However, Toronto carpet cleaning experts believe that with a little time and a few supplies, it is easy to fix a problem like this.

The first thing you’ll want to do is measure the area of the carpet that has been damaged and needs repairing. You should use a tape measure to accurately measure the size of the patch that will need to be taken up out of the carpet. This will make cutting the replacement patch for the area a lot easier since you know the exact measurements. You then want to tape off the area of the carpet that will be removed. You should use duct tape, because of the strong adhesive, to outline the piece of carpet that is to be removed. Once you put down the duct tape, you’ll want to measure the area again to check and make sure they match up with the dimensions of the previous measurements you made.

Once you do this, you are ready to remove the damaged section of your carpeting. You can use a utility knife or a carpet cutting tool to cut along the inside edges of the duct tape you placed as a guide. You want to apply enough pressure so that it cuts through the carpet, but not so much that it damages the padding underneath it. Once you have gone along all the edges of the duct tape, then you can lift the section of the carpet up off the surface.

You’ll then want to measure and cut the replacement patch for the area of the carpet you just removed. As many Toronto carpet cleaning say, you want to turn the carpet remnant face down and measure from the bottom side with a pencil and then use the utility knife or carpet cutter to cut out the patch of carpet.

Once all of the preparation is done, you can prepare the carpet to become one with the patch. When doing this, it is easiest to use an adhesive disk. First, you’ll want to neutralize the disk temporarily by putting a small amount of water on it so the adhesive isn’t as strong. Then you’ll want to lift the edges of the carpet surrounding the hole and place the adhesive disk underneath with the adhesive side facing upward. You want to make sure that the adhesive disk is larger than replacement patch because you want the disk to adhere to the replacement patch as well as some of the surrounding carpet. Then when the patch becomes sticky again, you want to press down on the outer edge of the carpet to lock it into place.

In order to make it look like there is no patch, must align the patch so that the direction of the fibers in the patch match the direction of the fibers in the rest of the carpet. After fifteen minutes. The glue will set and permanently anchor your patch in place so you want to work quickly. Finally, smooth the pile of the carpeting to hide the seams of the patch. Depending on the type of carpet, this may be accomplished by brushing your fingers around the perimeter of the patch, or using a carpet brush to encourage the fibers on the patch to move in the same direction as the rest of the carpet.